All Time Auto Graphics Installation Guides

Decals     Rear Window Graphics

DECAL APPLICATION

Our decals are very easy to apply.
To apply one of our decals to any smooth flat surface:
• For larger decals it is much easier to apply them with the help of a friend.
• Clean the surface very well. If it is being applied to glass, clean it with rubbing alcohol. If it will be going on a painted surface or wall clean the surface with a mild soap and water mixture.
• Hold the decal up to where you want to apply it. Go through the motion just as if you were installing the decal. This will aid in lining up the decal when applying it.
• Remove the clear tape from the backing. The decal will adhere to the clear tape as the tape pulls away from the backing. Be very careful not to let the tape or decal stick to itself while removing.
• Hold the decal just above where you would like it applied. Gently allow the middle to touch the surface. Then let the edges down gently.
• Use a license, credit card, or other flat smooth object to scrape across the tape. Do this to remove any air bubbles and activate the glue. The decals are pressure sensitive so the more pressure you apply the better it will stick.
• Gently start at one corner and pull the tape back at a very sharp angle. The tape should pull free of the decal leaving just the decal on the surface.
That's it... you now have installed your new decal.

Please note that it is much easier to apply the decals if the temperature is above 45 degrees Fahrenheit.